3 Inch Shrink Wrap Tube Merchandise

Create Your Own Tool Grips With Heat Shrink Tubing

By wrapping the tool with a piece of copper wire, then with 2 1/2-inch heat shrink tubing, they were able to add a grip to one of their tools. It should work with about any larger tool, but you'll ...

Fix-It Chick: Replace trailer light plug end in 11 quick, easy steps

Step 5: Cut four 3-inch-long pieces of heat-shrink tubing and slide a piece onto each of the four ... Step 11: Once all of the connections have been sealed, wrap the wires as a bundle from top to ...

Shrink Wrapping for Winter

Screw a 4-inch-square ... them at about 3 feet. Secure the additional uprights to the lifelines with wire ties and lash their bases in place so they couldn’t move from side to side. To install straps ...

Cut the Cable! Build Your Own Digital TV Antenna

To assemble this DIY design, get 32-inch- and 6-inch-long 1 x 4 pine boards; eight 17-inch lengths and two 34-inch lengths of bare 12-gauge copper wire (for the ears and phasing bars); heat-shrink ...

Dymo Rhino 1/4" Heat Shrink Tubes, 5' Roll, White

Much easier, quicker to install than wrap around. Cons: Rhino printer wastes tape by feeding extra margin on each end (work around: type more than one label before printing using 3 or 4 space bars in ...

PEARLabel 270 and PEARLabel 360 label printers

It can also import graphics and Excel/Word data. The PEARLabel 360 prints 360 dots-per-inch (dpi) on 126 different industrial heat shrink tube, wire wrap, and special labeling materials from 1/6 inch ...

DYMO XTL Series Industrial Label Printers from AutomationDirect

and the ability to print up to 2-1/8 inch (54mm) wide labels. XTL labels come as all-in-one cartridges with the labels and printing tape rolled up inside or as laser compatible printer sheets. Label ...

SpinTech Oval-Tube Exhaust Systems – Exhaust With A Twist

By 1997, when SpinTech developed the use of oval tubing in their exhaust systems, things really started to get interesting. By using oval-shaped tubing, they were able to effectively run the same ...

DIY: Transform an Old Film Canister Into a Tiny Flashlight for Your Camera Bag

All you need to get started is some hot glue, a 3-volt battery ... but if you don’t want to solder you can wrap the wires on and then use electrical tape or heat shrink tubing to keep them in place). ...

Create Your Own Tool Grips With Heat-Shrink Tubing

By wrapping the tool with a piece of copper wire, then with 2.5-inch (6.35cm) heat-shrink tubing, they were able to add a grip to one of their tools. It should work with about any larger tool, but you ...